︎
 
 
 
 
1. Adding Pancake Pleating

 
1/9 To start select section that will be pleated. 2/9 Move these surfaces in the 2D and 3D window. To allow space to copy and move additional surfaces next to original. 3/9 Select and isolate surface, while freezing all other surfaces. Copy this surface and place it stacked next to the original. 4/9 Stitch the outside edges to one another 5/9 After stitching all edges the surface should look similar to the screen shot 6/9 Once this is complete you can assign different materials to each surface. Keep in mind that different surfaces will react against each other. So here there are only to,this will prevent internal crashing. 7/9 After adjusting the materials simulate the set of surfaces. 8/9 The reaction should look similar to the screen shot. As in there are no material collisions. 9/9 Side view of material